Find the latest bookmaker offers available across all uk gambling sites www.bets.zone Read the reviews and compare sites to quickly discover the perfect account for you.

TraSys® Semi-Permanent, Water-Based Rubber Mold Release Coatings.

Benefits


Molders specify ready-to-use Stoner™ TraSys® semi-permanent water-based rubber release coatings because they:

  • Are cost-effective
  • Reduce frequency of spray at press stations
  • Reduce transfer to molded product
  • Provide highly effective and economical release

TraSys® 9825
» More Info.

TraSys® 428
» More Info.

TraSys® 818
» More Info.

TraSys® 708
» More Info.

Release Type.

Semi-Permanent, General-Purpose Semi-Permanent, High Release Semi-Permanent, General-Purpose Semi-Permanent, Light Release

Resin Carrier.

Water Water Water Water

Typical Uses.

Injection, Transfer, General-Purpose Compression Transfer, Injection, Higher Temp. Molding Compression Transfer, Injection, General-Purpose, Touch-Up Injection, Transfer, General-Purpose, Compression

Compatible Compounds.

Fluoroelastomers, NBR, EPDM, Most Compounds Organic Polymers Organic Polymers and Natural Rubber Fluoroelastomers, NBR, EPDM, Most Compounds

Apply to Mold.

Hot Molding Temperature Hot Molding Temperature Hot Molding Temperature Hot Molding Temperature

Min. Cure Temp. / Min. Cure Time.

132°C (270°F) / 5 minutes 132°C (270°F) / 5 minutes 132°C (270°F) / 5 minutes 132°C (270°F) / 5 minutes

Maximum Operating Temperature.

190°C (380°F) 232°C (450°F) 327°C (620°F) 205°C (401°F)

Agitation Required.

Slight Slight Yes Slight

Product Cosmetics.

Satin Semigloss Satin Satin

Affected by Freeze?.

No Yes This product is NOT freeze/thaw stable. Yes This product is NOT freeze/thaw stable. No

Comments.

First Choice for Specialty Rubbers, Vamac®, Viton®, Aflas®. Excellent Ability
to Bond to Plated or Polished Surfaces
Highest Slip. Good for High-Flow Injection Molding Good for Rubber to Metal Bonding. Best for Silicone Elastomers.
Good Touch-Up for Permanent Fluorochemicals
First Choice for Specialty Rubbers, Vamac®, Viton®, Aflas®. Excellent Ability to
Bond to Plated or Polished Surfaces.
1. Non-ozone depleting, noncarcinogenic solvent, No VOC content.
2. Hot to the touch; approximately 48°-60°C (120°-140°F).
3. Inner mold temperature; normally accomplished by cycling coated mold when empty.
4. Air cures rapidly on substrates at 32°-38°C (70°-100°F). Introduction of 149°C (300°F) heat after application enhances cure and prolongs durability of coating.

TraSys® Rubber