Find the latest bookmaker offers available across all uk gambling sites www.bets.zone Read the reviews and compare sites to quickly discover the perfect account for you.

TraSys® Pioneering Water-Based Technology for the Rotational Molding Industry.

Benefits


Stoner Coating & Release Systems supply the plastic rotational molding industry with the best in water-based mold release coatings. Free of alcohol and solvents, these coatings meet all existing and anticipated environmental regulations. Stoner coatings yield consistent, controlled release for maximum performance. Rotational molders use Stoner release coatings because:

  • Their long life can reduce the need for frequent operator spraying
  • They are safe, easy to use, and work with LLDPE, LDPE, MDPE, HDPE, LXPE, PP, plastisol, and nylon
  • They exhibit minimal transfer of release materials to the molded product
  • They produce consistent parts without warpage or sticking, allowing your production to run smoothly
  • Stoner provides qualified, expert technical support

TraSys® 420
» More Info.

TraSys® 414
» More Info.

TraSys® 500
» More Info.

TraSys® 715
» More Info.

NEW! RotoFlow™ TraSys® 4000
» More Info.

Release Type.

Semi-Permanent, General-Purpose Semi-Permanent, High Release Semi-Permanent, General-Purpose Semi-Permanent, Light Release Mold Coating Flow Enhancer

Resin Carrier.

Water Water Water Water Solvent

Typical Uses.

Mold Internals Part Lines, Removable Pins, High Releases Mold Internals, Open Flame Large Flat Surfaces, Difficulty in Containing Warpage Resin flow enhancer, inserts, pin hole removal

Solvent Free.

Yes Yes Yes Yes No

Alcohol Free.

Yes Yes Yes Yes Yes

Recomm. Compat. Compounds.

LLDPE, LDPE, MDPE, HDPE, XLPE, PP, Nylon, Plastisols LLDPE, LDPE, MDPE, HDPE, XLPE, PP, Nylon, Plastisols LLDPE, LDPE, MDPE, HDPE, XLPE, PP, Nylon, Plastisols LLDPE, LDPE, MDPE, HDPE, XLPE, PP, Nylon, Plastisols LLDPE, LDPE, MDPE, HDPE, XLPE, PP, Nylon, Plastisols

Apply to Mold.

Warm2 Warm2 Warm2 Warm2 Warm2

Min. Cure Temp. / Min. Cure Time.

132°C (270°F)3 / 5 minutes 132°C (270°F)3 / 5 minutes 132°C (270°F)3 / 5 minutes 132°C (270°F)3 / 5 minutes 132°C (270°F)3 / 5 minutes

Agitation Required.

Slight Slight Slight Slight Shake can until ball breaks loose

Product Cosmetics.

Satin Satin Satin Satin Satin

Appl. Frequency.

Varies with Function Varies with Function Varies with Function Varies with Function Every part

Action if Frozen.

Thaw, Agitate Thaw, Agitate Thaw, Agitate Thaw, Agitate N/A
1. Non-ozone depleting, noncarcinogenic solvent, No VOC content.
2. Hot to the touch; approximately 48°-60°C (120°-140°F).
3. Inner mold temperature; normally accomplished by cycling coated mold when empty.
4. Air cures rapidly on substrates at 32°-38°C (70°-100°F). Introduction of 149°C (300°F) heat after application enhances cure and prolongs durability of coating.

TraSys® Rotational